Particle Xenon IoT Development Kit includes Xenon development board, mini breadboard, and USB cable. This Xenon development kit is a low-cost mesh-enabled kit that can act as an endpoint or repeater within a Particle Mesh network. The Xenon development board is based on the Nordic nRF52840 Bluetooth development tool and has built-in battery charging circuitry. This helps in easy connection with Li-Po and to deploy the local network in minutes. The Xenon IoT development kit is best suited for connecting sensors, motors, pumps, valves, and points of data-interest. This Xenon board in combination with an Argon or Boron gateway gets all that great data into the Device Cloud.
Specifications
Nordic Semiconductor nRF52840 SoC
ARM Cortex-M4F 32-bit processor @ 64MHz1MB flash and 256KB RAMIEEE 802.15.4-2006: 250KbpsBluetooth 5: 2Mbps, 1Mbps, 500Kbps, and 125KbpsSupports DSP instructions and HW accelerated Floating Point Unit (FPU) calculationsARM TrustZone CryptoCell-310 Cryptographic and security moduleUp to 8dBm TX power (down to -20dBm in 4dB steps)NFC-A tagOn-board additional 2MB SPI flashOn-board PCB antenna20 mixed signal GPIO (6x Analog, 8x PWM), UART, I2C, and SPI
